WeldMax LC 518D

This is a nice all-in-one unit. High Frequency DC Plasma cuts thicker materials than standard DC plasma cutter and with less distortion.

Video of the Day

Specs:

Operating Dual Voltage:
208/220vac 50/60HZ Input Single Phase 1PH
110/120vac 50/60HZ Input Single Phase 1PH
50amp cut draws 25Amps
40amp cut draws 22.5Amps
230V No Load Voltage, 100-115V Working Voltage

Cutting Specs:
3" Per minute @ 1" Steel (Severance Cut)
7" Per minute @ 3/4" Thick Steel
17" Per minute @ 1/2" Quality Cut

* 50 Amps Plasma cutter: Duty Cycle 60% at 50 Amps and 100% at 40 Amps. 3/4 inches clean cut with 7.2 inches per minutes; 1.0inches severance cut with 3.1 inches per minute. Rated Output Current is 40Amps under both AC 110V and 220V. Works in both 50 and 60 Hz with operating air pressure as 65 psi @ 3 cfm.

Welder Specs:
TIG and Arc Welder

* 180 Amps DC Tig Welder: Duty Cycle 60% at 160 Amps
* ARC and 100% at 95 Amps ARC. Gas Flow: 2-5 L/Minute. It can weld all stainless steel. 160 Amps Arc Welder: Duty Cycle 60% at 160 Amps and 100% at 110 Amps.
* DC welders do not weld aluminum.

High Frequency DC Plasma cuts thicker materials than standard DC plasma cutter and with less distortion.

Built in Thermal and Overload Protection

Weight: 40Lbs

You get...

* Main Unit
* Cutting Torch FREE 60AMP TORCH UPGRADE!
* TIG Torch
* Stick Holder
* Earth Clamp
* Air Regulator with Bracket
* Air Hose
* Foot Pedal
* Argon Regulator
* Consumables: 3 piece tips, 3 piece electrodes, 3 piece gas diffuser, 3 piece shield cups

Does not weld aluminum.